TP 18DX NaceCare 18 Galon DUAL-MOTOR Box Extractor
•
|
Rugged two piece roto molded polyethylene |
•
|
Powerful 2.6 Hp ( 2 x 1.3 Hp ) 2 stage vacuum motors provides 100" waterlift and 212 CFM of airflow |
•
|
Features a 100 PSI diaphragm pump with bypass providing 1.1 gpm of flow |
•
|
Lightweight and easy to transport with the upper and lower tanks detaching into two separate units |
•
|
The large 18 gallon tanks enable it to tackle even the biggest commercial jobs |
•
|
Optional heater available |
The TP 18DX is a premium extractor featuring a 100 PSI diaphragm pump with a bypass providing 1.1 gpm of flow. Even the biggest commercial jobs can be tackled with the large 18 gallon tanks.
The TP 18DX features 2.6 Hp ( 2 x 1.3 Hp ) 2 stage vacuum motors, providing 100" waterlift and 212 CFM of airflow. An optional heater is available.
The TP 18DX come complete with a 20' solution/vacuum hose and a 3 jet wand.
OPTIONAL PRE-SPRAY SMART KIT
The SMART KIT can be added to the AV 12QX, AV 18AX and TP18 DX or TP18 SX. As pre-spraying is the key component in proper carpet cleaning, this kit is a breakthrough.
For the same reason we allow stripper dwell time prior to scrubbing and don't dispense it through the scrubber, pre-spraying is critical in ensuring effective carpet cleaning.
It uses the extractor pump to dispense an onboard chemical through a 50' pre-spray hose.
ADVANTAGES:
• One man can do the job of two while easily ensuring enough pre-spray is applied at all times. With other systems, you require a second man doing nothing but pre-spraying otherwise your machine is sitting dormant half the time while you either fill the sprayer or apply the spray.
• 12 or 18 gallon solution tanks ensure ample pre-spray and cleaning solution is available.
• Unlike manual or electric sprayer systems, you are not re-filling every 5 minutes.
• Ensures a consistent and correct dilution at all times with constant flow and no pumping.
• More powerful than any other system which means you can apply pre-treat a lot more quickly.
• Can spray for 30 minutes (AV12QX) or 45 minutes (AV18, TP18) before re-filling. An electric sprayer would need to be refilled every 5-7 minutes.
INTERIM MAINTENANCE SPRAY BAR KIT
Our new low moisture spray bar uses 3 jets instead of 5 and applies water to the carpet at a rate of 0.2 gallons per minute versus the normal rate used in restoration cleaning of 1.0 gallon per minute.
Extensive testing has found that our system does an effective job of maintaining all carpet areas including high traffic areas. In most cases, the carpet dries in UNDER 90 MINUTES without the use of a carpet fan, however, these drying times can be significantly reduced when carpet fans are employed.
We can effectively clean in excess of 4,000 square feet per hour in both maintenance and restorative modes with the AV12QX and AV18X.
NOTE: In order to use the low moisture spray bar, the machine must have a pre-spray
Smart Kit installed.
|
Airflow |
212 cfm (max.) |
Vacuum Motor |
2 – 1000 W/ 1.3 Hp 2 stage |
Waterlift |
100 ins |
Weight |
95 lbs |
Power Cord |
42 ft |
Pump Type |
diaphragm with bypass |
Pump Pressure |
100 psi |
Pump Power |
100 W |
Pump Flow |
1.1 gpm |
Capacity – solution |
18 gal |
Capacity – recovery |
18 gal |
|
|
Click Here for more information on this product
Complete Product Specificationsand Owner's Manual.
These documents are in Adobe Acrobat (PDF) format.
You will need Adobe Acrobat Reader to view and print these documents.
Click for additional product bid specs